![]() The port does not come pre-threaded, so the initial installation will be tight. ![]() Place the new face plate on the figure, replace the screw. Unscrew the screw in the Titan Master's chest. Detail plastic prints will need a light washing with soap and water prior to painting to remove support material residue. Use a toothpick or pin to remove any support material inside the connector ports on the back of the face. Some fine details may not show up clearly on prints in strong & flexible plastic. As prints vary, some sanding/trimming may be required, and some Titan Masters (like Blurr) lack the rectangular connection peg and gluing may be required to fully secure the face. This replacement faceplate connector has been tested using Titan Wars Skullsmasher and Blurr, and should be compatible with most Titan Master mini-figures. These kits allow for customization of the face while keeping the moving parts and head/body connection from the mass-produced figure for the best fit between head and body. A replacement face-kit for Transformers: Titans Return Titan Master figures.
0 Comments
Leave a Reply. |